Standard Barrel Clamp, 12ga

Nordic extension tubes are tough, but some situations just require some extra support. Whether it's just there to provide a place to attach a light or sling, or if it's the last thing standing between that barricade you just slammed your extension tube into and launching the contents of your magazine downrange, our barrel clamp gets the job done.

The Nordic Components standard shotgun barrel clamp provides extra rigidity for your magazine extension on most shotguns (see excluded models below). Each clamp half has a centrally-located 10-32 threaded hole to accept accessories, such as a sling stud or our barrel clamp tac rail or QD sling mount.

Not compatible with:

• Mossberg 590/590A1, 835, 935, or 930SPX shotguns (requires heavy-wall barrel clamp)
• Benelli Nova/Supernova (requires heavy-wall barrel clamp)
• Browning Auto-5, Remington Model 11, Savage 720/725, or any other shotguns with reciprocating barrels

If your shotgun isn't listed above and wasn't made by someone in his garage, then this clamp will probably work.

Designed for Nordic MXT Extension tubes (1.060" diameter) but may be compatible with other models.

Note: The shotgun barrel clamp makes contact with your barrel and may cause finish wear with use. We recommend applying masking tape to the inside of the clamp fingers that contact the barrel to alleviate this potential wear or using the Stacra barrel clamp gasket. Because we have no control over the installation of this product, Nordic Components is not responsible for any resulting wear or damage.